Sealing King is a new generation of high-efficiency, moisture-proof, and impermeable multifunctional sealing material developed by our factory by absorbing the advantages of similar products at home and abroad, and improving and updating them with a unique formula. It is also an excellent adhesive material. This product is a single component gray powder. Its main technical indicators are higher than similar domestic products and reach the international advanced level. Its characteristics are fast setting and hardening, extremely short initial and final setting time interval, and rapid strength generation after final setting. The strength is greater than 10MPA in 15 minutes and greater than 20MPA in 1 hour. It can not only quickly block leaks with water locally, but also prevent seepage on a large area, operate with water, and stop leaks quickly when encountering water. This product is easy to construct, has strong adhesion with the base layer, does not shrink or fall off, and can be widely used for leak sealing, water sealing, emergency repair and grouting in buildings, underground tunnels, mines and other engineering projects. This product is non-toxic, harmless, and environmentally friendly.

Product number: LD-2401

Product specifications: 20KG/box (2KG * 10 bags) (4KG * 5 bags)

Construction steps

1. Prepare materials and tools and clean cracks

2. Mix powder and water in a ratio of about 1 to 0.3 in the west

3. Mix the water and powder evenly with a shovel

4. Evenly smooth the cracks and let them dry

Common problems during construction

Phenomenon: The initial setting time of the plugging king is relatively long

1. The construction environment temperature is relatively low,

2. Incorrect water mixing ratio and uneven mixing can cause excessive initial setting time, and in addition, the material is unqualified

Can the plugging king directly replace ceramic tile adhesive bricks?

No, because the adhesive of the plugging king is not enough, which can cause the tiles to be hollowed out, cracked, and deformed.

Matters needing attention

1. The setting time may fluctuate due to differences in water consumption and construction temperature.

2. After opening this product, to avoid affecting its performance, unused products should be resealed.

3. Unopened products should be stored in a dry, cool, and ventilated place, and contact with water is strictly prohibited.

4. This product has strong alkalinity, and corresponding protective measures should be taken during construction.

5. When condensing, a large amount of heat will be generated, and caution should be taken to avoid burns.

6. Due to the short solidification time of this product, it is recommended to adjust and use it immediately to avoid unnecessary waste.