Product Introduction:

This product is a waterproof, crack resistant, moisture-proof, and alkali resistant mortar made by mixing various components such as dispersible adhesive powder and blue crystal powder with special cement and quartz sand. A polymer universal waterproof mortar that can be used for both backwater and backwater surfaces. It can be used for slow infiltration in basements and is waterproof and moisture-proof.

Product number: LD-2605

Specification: 18KG

Product performance:

1. The construction thickness can reach 6-8mm at once, making it easy to scrape.

2. The impermeability pressure is high, far exceeding 1.5MPa in 28 hours

3.28d, with a strength of over 20MPa and resistance to impact.

4. Strong adhesion, no hollowing, cracking, peeling or other phenomena.

5. Construction can be carried out on both the upstream and downstream surfaces.

D006 composite inorganic waterproof coating:

1. The universal polymer mortar made from a patented product of the company can be used for sealing leaks and cracks on the upstream and downstream surfaces;

2. 7d impermeability pressure of 3.6Mpa, exceeding the waterproof standard of polymer mortar.

3. A water pool with a thickness of 4mm can achieve excellent construction results, while underground works with a thickness of 6mm and roofs or exterior walls with a thickness of 3mm can achieve good anti-seepage effects.

construction technology 

1. Construction preparation: Before construction, quality inspection should be carried out on the base layer to remove loose layers, oil stains, dust and other debris from the base layer; Holes, gaps, and other areas should be repaired and leveled, and the smooth surface should be roughened; The vertical surface of the grassroots ground must be flat, sturdy, free from sand, skin, and looseness. When constructing brick walls, ensure that there is no floating sand at the brick joints.

2. Wet the base surface: Sprinkle water to fully wet the base surface. The base surface should be clean, damp, and free of open water. Waterproofing construction should not be carried out on unqualified base layers.

3. Mixing: When mixing mortar on site, add about 10% -20% water to the mortar powder of this product. The specific amount of water should be comfortable for personal use and as little water as possible. After sufficient mixing for 2-3 minutes, construction can only be carried out without clumping. The mixed mortar should be used up within 30 minutes, and no secondary water should be added during the construction process.

4. Layered construction: The mortar of this product should be constructed using the wiping and pressing method, and the layered application should be scraped and pressed repeatedly in both vertical and horizontal directions. When layering and pressing, the thickness of a single layer should be greater than 6mm. After the previous layer of mortar has basically solidified, the next layer of mortar should be applied for waterproofing and moisture-proof construction in water tanks and basements. The thickness should be 6-10mm (the thinnest part should not be less than 6mm); The construction thickness for basement infiltration and slow infiltration treatment is generally 8-10mm, which is thickened according to the water pressure of infiltration and slow infiltration. The thickness for exterior wall construction is 4-6 mm (the thinnest part is not less than 4mm); Used for roof construction with a thickness of 5-8mm (not less than 5mm at the thinnest point). During the retarding period, it is necessary to carry out grouting and polishing.